- 
                Notifications
    You must be signed in to change notification settings 
- Fork 10
docs_interface_prepare blackbox
        peter edited this page May 14, 2025 
        ·
        2 revisions
      
    The following instructions cover the neccesary steps to configure an OpenBuilds BlackBox to talk to an OpenBuilds Interface via the AUX serial port on the BlackBox.
Note this section is split into sections, based on the version of BlackBox you have:
On some versions you can peek in through the side vent holes and see the version numbers without removing the cover, if not, you can remove the top panel of your BlackBox, the version numbers are printed on the Brains board inside:
For example:

Check what version you have, and follow the relevant section to prepare your BlackBox
- NEXT: Prepare your OpenBuilds BlackBox 4X V2.3 - 2.7
- NEXT: Connect your OpenBuilds BlackBox 4X V2.8 - 2.10 or newer (no preparation required)
- NEXT: Connect your OpenBuilds BlackBox X32 V1.2 or newer (no preparation required)