Add Voron 2 MKS Monster 8 V1.0 in SPI mode; This PR will not work properly without PR #259 #258
Conversation
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
GadgetAngel
changed the title
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
2 participants
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
*Add Voron 2 MKS Monster 8 V1.0 in SPI mode, This PR will not work properly without PR #259 . It contains a link to the information in PR #259
*In Community/Electronics/ added the following:
*updated Index.md file in Community/Electronics/ to add "Voron V2 - MKS Monster 8 V1.0 Wiring for both SPI and UART modes" (v2_monster8_wiring.md)
*v2_monster8_wiring.md is a parent to v2_monster8_spi_wiring.md
*reused two additional files:
a. monster8_RaspberryPi.md
b. monster8_Resources.md
*added initial Removal of Jumpers diagram
*added initial preparation - Set Jumpers diagram for MKS Monster 8 V1.0 in SPI mode
*added description for Voron 2.4 wiring diagram in MKS Monster 8 V1.0 in SPI mode
*added the heatsink diagram to remind user to ensure that the heatsinks are installed on the stepper motor drivers for:
*Added the following MCU with heat sinks in SPI mode
*added URL to the Klipper Configuration by RealDeuce (https://raw.githubusercontent.com/VoronDesign/VoronUsers/master/firmware_configurations/klipper/RealDeuce/MKS-Makerbase/Monster8_v1.0_003/Voron2_Monster8_Config.cfg) for MKS Monster 8 V1.0
*informed user that the above config file by RealDeuce needs to be changed from UART to SPI
*added links to other resources