k210-camera-project

This is a simple project for k210 with drivers of different camera type,support save image to sd-card by jpeg or bmp.

Get source code

• Clone by https link

git clone https://github.com/PureHing/k210-camera-project.git

• Then get submodules

git submodule update --recursive --init

It will regiter and clone all submodules, if you don't want to register all submodules, cause some modules is unnecessary, just execute

git submodule update --init
# or 
git submodule update --init path_to_submodule
# or
git submodule update --init --recursive path_to_submodule

Install dependencies

Ubuntu for example:

sudo apt update
sudo apt install python3 python3-pip build-essential cmake
sudo pip3 install -r requirements.txt

recommend python3 instead of python2

Check CMake version by

cmake --version

The cmake version should be at least v3.9, if not, please install latest cmake manually from cmake website

Download toolchain

Download the latest toolchain from here, or kendryte-toolchain-ubuntu-amd64-8.2.0-20190409.tar.xz(CDN)

And extract to /opt/kendryte-toolchain/

For example:

wget http://dl.cdn.sipeed.com/kendryte-toolchain-ubuntu-amd64-8.2.0-20190409.tar.xz
sudo tar -Jxvf kendryte-toolchain-ubuntu-amd64-8.2.0-20190409.tar.xz -C /opt
ls /opt/kendryte-toolchain/bin

Configure project

• Switch path to testproject project director

cd projects/testproject

or

cd projects/dvp2lcd

• Configure toolchain path

The default toolchain path is /opt/kendryte-toolchain/bin, and default toolchain pfrefix is riscv64-unknown-elf-.

If you have copied toolchain to /opt, just use default.

Or you can customsize your toolchain path by

python project.py --toolchain /opt/kendryte-toolchain/bin --toolchain-prefix riscv64-unknown-elf- config 

And clean config to default by command

python project.py clean_conf

• Configure project

Usually, just use the default configuration.

If you want to customsize project modules, execute command:

python3 project.py menuconfig

This command will display a configure panel with GUI, then change settings and save configuration.

Build

python3 project.py build

And clean project by:

python3 project.py clean

Clean all build files by:

python3 project.py distclean

The make system is generated from cmake, you MUST run

python3 project.py rebuild

to rebuild make system after you add/delete source files or edit kconfig files

Flash (Burn) to board

For example

python3 project.py -B dan -p /dev/ttyUSB0 -b 1500000 -S flash
or
./download2board.sh

-B means board, -p means board serial device port, -b means baudrate, -S or --Slow means download at low speed but more stable mode.

the configuration saved in .flash_conf.json except args: --sram(-s)、--terminal(-t)、--Slow(-S) You don't need to confiure again the next time you burn firmware, just use:

python3 project.py flash

or

python3 project.py -S flash

More parameters help by :

python3 project.py --help

Others

Build system: refer to c_cpp_project_framework and MF1-SDK