0.957 Linux x64 and Raspberry Pi x64

Linux x64 python 3.8
RPI x64 python 3.9

-Log files are reduced to 10 MB if over 50 MB on webcontrol startup. This likely will not fix the problem if webcontrol never restarts. Code checks for log.txt and then if there it checks the size.
-avrdude is included for sending hex file to the mega controller. tested on Linux as working. Not tested on rpi. Only avrdude and avrdude.conf are needed and can be copied from arduino share folder.
Remaining to do:

mobile versions of pages
python 3.10

0.955 Linux x64 and x64 RPI

Z axis PID menu functions using B13 and B14 commands similar to how the left and right pid motor testing is done.
Merged 2022 updates with the master branch.

webcontrol basic functionality tested ok. Action menu continues to load.

updated code from master checks for even/odd version number. even is stable. Odd is developmental. all release numbers from here on that are untested will be odd numbers.

Linux x64 python 3.8
RPI x64 python 3.9

both have maslowcnc 1.29 (placeholder version essentially 1.26, but numbered higher for newer shields)
both have holey 1.30 firmware included

Remaining to do:

log file overrun
mobile versions of pages
python 3.10

0.954 Linux x64 and RPI x64

Linux x64 python 3.8
RPI x64 python 3.9

both have maslowcnc 1.29 (placeholder version essentially 1.26, but numbered higher for newer shields)
both have holey 1.30 firmware included

Remaining to do:

• zPID page functionality
• python 3.10
• log file overrun
• mobile versions of pages

0.95b Linux x64 and RPI test release - new feature testing release

Linux single directory for 64bit linux - single folder setup only.
RPI single directory on buster - single folder setup only.

Both are 0.95b version Webcontrol with 5 macro buttons, GPIO and LED indicator button services available, and functioning build scripts. Firmware included in these distributions are 1.28 and 51.30 for the mega supporting shield versions up through 1.10.

The gcodeclean menu item is not yet functional.

0.95a is a patched 0.95 release for 1.5b shield

Raspberry pi pre-release beta.

• added AVR_dude so it will actually flash the arduino
• Newer Beta of holey-51.29.hex for the 1.5b eastbay shield for testing. (does not work yet)

0.95 prerelease Beta for Raspberry Pi with new firmware

New Features:
-Z axis limits added to allow user to define upper and lower limits supported in 51.29 firmware
-Advanced settings for spindle lower and upper limit speed setpoints to allow S gcode command to control pwm spindle output speed on pin 45 in 51.29

• Advanced setting changed spindle from servo to speed control (may not change unless new webcontrol.json file used...)
  -Included Firmware
  -- 51.28 firmware (makerverse compatible)
  -- 51.29 beta firmware (makerverse compatible, z-axis limits and patch for eastbay shields)
  -- 1.26 firmware (shipping firmware) to action menu buttons for auto flash