本电路由可否适配？ #35
Description
U-Boot 2017.09 (Aug 08 2024 - 11:41:53 +0000) OpenWrt
Model: Rockchip RK3568 Board
MPIDR: 0x81000000
PreSerial: 2, raw, 0xfe660000
DRAM: 4 GiB
Sysmem: init
Relocation Offset: ef3fc000
Relocation fdt: ed9e6ae0 - ed9fed00
CR: M/C/I
I2c0 speed: 100000Hz
rk8xx_read: read reg 0xed failed, ret=-121
io-domain: OK
*** Warning - No MMC card found, using default environment
MMC: dwmmc@fe2b0000: 1, dwmmc@fe2c0000: 2, sdhci@fe310000: 0
Model: Rockchip RK3568 Board
MPIDR: 0x81000000
rockchip_set_serialno: could not find efuse/otp device
Card did not respond to voltage select!
mmc_init: -95, time 9
switch to partitions #0, OK
mmc0(part 0) is current device
Bootdev(scan): mmc 0
MMC0: HS200, 200Mhz
PartType: DOS
No misc partition
boot mode: None
CLK: (sync kernel. arm: enter 816000 KHz, init 816000 KHz, kernel 0N/A)
apll 816000 KHz
dpll 780000 KHz
gpll 1188000 KHz
cpll 1000000 KHz
npll 1200000 KHz
vpll 24000 KHz
hpll 24000 KHz
ppll 200000 KHz
armclk 816000 KHz
aclk_bus 150000 KHz
pclk_bus 100000 KHz
aclk_top_high 300000 KHz
aclk_top_low 200000 KHz
hclk_top 150000 KHz
pclk_top 100000 KHz
aclk_perimid 300000 KHz
hclk_perimid 150000 KHz
pclk_pmu 100000 KHz
Net: eth1: ethernet@fe010000, eth0: ethernet@fe2a0000
Hit key to stop autoboot('CTRL+C'): 0
Card did not respond to voltage select!
mmc_init: -95, time 9
switch to partitions #0, OK
mmc0(part 0) is current device
Scanning mmc 0:1...
Found U-Boot script /boot.scr
366 bytes read in 1 ms (357.4 KiB/s)
Executing script at 00c00000
59551 bytes read in 2 ms (28.4 MiB/s)
19349512 bytes read in 122 ms (151.3 MiB/s)
Fdt Ramdisk skip relocation
No misc partition
Flattened Device Tree blob at 0x08300000
Booting using the fdt blob at 0x08300000
Using Device Tree in place at 0000000008300000, end 000000000831189e
Adding bank: 0x00200000 - 0xf0000000 (size: 0xefe00000)
Adding bank: 0x1f0000000 - 0x200000000 (size: 0x10000000)
Total: 2682.504/2689.473 ms