diff --git a/arduino/papercounter.c b/arduino/papercounter.c
new file mode 100644
index 0000000..39b0dfd
--- /dev/null
+++ b/arduino/papercounter.c
@@ -0,0 +1,56 @@
+#include <Wire.h>
+#include <LiquidCrystal_I2C.h>
+
+LiquidCrystal_I2C lcd(0x3F,20,4);  // set the LCD address to 0x20 for
+a 16 chars and 2 line display
+
+const int trigger = 10;
+const int echo = 9;
+
+// const float durchmesser = 3.8;
+// const float pfand = 0.25;
+
+// unsigned long lastAktion = 0;
+// unsigned long timeout = 10000;
+
+float distance;
+
+int count = 0;
+int old_state = 0;  // 0 = Low, 1 = High
+
+void setup(){
+  Serial.begin(9600);
+  pinMode(trigger,OUTPUT);
+  pinMode(echo,INPUT);
+
+  lcd.init();                      // initialize the lcd
+
+  // Print a message to the LCD.
+  lcd.backlight();
+  lcd.print("Rollen Messung... ");
+}
+
+void loop(){
+//Initialize the sensor
+  digitalWrite(trigger,LOW);
+  delayMicroseconds(5);
+//We start the measurements
+//We send out a signal activating the trigger output for 10 microseconds
+  digitalWrite(trigger,HIGH);
+  delayMicroseconds(10);
+  digitalWrite(trigger,LOW);
+//We acquire the data and We convert the measurement to meters
+//We measure the pulse width
+//When the pin is HIGH It will measure the amount of time until it is LOW)
+  distance=pulseIn(echo,HIGH);
+  distance=distance*0.01657;
+
+//We send the measured data through the serial port and to the LCD display
+  lcd.setCursor ( 0, 1 );        // go to the first line
+  lcd.print(distance);
+  lcd.print("cm                  ");
+  Serial.print(distance);
+  Serial.print("cm  ");
+
+  delay(200);
+}