setup/dt-blob-dpi.dts does not have references to the Pi2

[robertely]

dt-blob-dpi.dts does not have a stanza for the Raspberry Pi 2. Preventing this from working.

I've been trying to find a device tree with a video core config for the Pi 2 but I can't find enough information.

[gertvanloo]

I do not have any control over the software. I know the VGA adapter was tested with the Pi-2 as I have seen it working with one of the production prototypes. As far as I know the drivers are part of the standard image. For all other matters post at "http://www.raspberrypi.org/forums/viewtopic.php?f=100&t=86658"

[6by9]

Pi2 has used the bplus pins config until the firmware commit Hexxeh/rpi-firmware@a1621d6 on 30th May.
Things have just changed - Phil is on it. (I've hit the issue when linking to a DPI screen via an Adafruit Kippah)

[pelwell]

The new dt-blob has more configurations, each of which has a few more defines:

• rev1
• rev2
• bplus1 // Pi 1 Model B+ rev 1.1
• bplus2 // Pi 1 Model B+ rev 1.2
• aplus
• 2b1 // Pi 2 Model B rev 1.0
• 2b2 // Pi 2 Model B rev 1.1
• cm

The reason for the change has been to document the variations in hardware and to replace some of the board-specific code with additional usage of the pin configuration data.

It's a shame that the external dt-blob is a complete replacement for the internal one rather than a patch to it, but changing that isn't something to do in a hurry. Instead, we've uploaded the new structure here, and you just need to overwrite pins 2-21 for the 5 (sorry) configurations for B+-compatible boards.