Knomi only shows standby GIF

[bthubs]

I cannot for the life of me get Knomi to work properly. Knomi is able to connect to my printer but it just stays on standby mode most of the time. The only thing I've been able to get working is homing after adding macro _KNOMI_STATUS per user Surio79 and flashing it per Cyanodil's post on the same thread. Probing is supposed to work with this macro but it doesn't for me. This is all on a Micron+. I rebooted the Knomi to work with my v2.4 and it works perfectly fine there, which is strange because I built the Micron+ using the same config files I used on the v2.4. I suspect it is a moonraker problem. Not sure this is related but for some reason, in fluidd, under the print jobs, there's no data listed for "Last printed" even though I've printed files before. This data does appear on my v2.4. Additionally, I've tried reflashing my CB1 with fresh version of klipper, as well as change my motherboard from manta m8p + cb1 to octopus max ez + pad7. Even tried a cb1 emmc with fresh klipper. Still no luck. After these changes, I still don't get any information under "Last printed". I've spent days trying to figure this out, I have 3 Knomis, none of which can connect to my Micron+, all of which can connect to my v2.4. I'm about to try a completely customized UI but I'd thought I'd try my luck here before doing that.

Any bright minds out there have any idea wtf is going on?

[bthubs]

Got it to work. I'm not completely sure this is the issue but it seems to be a problem with the "minimal" cb1 version. When I would do [printer ip]/api/printer with the minimal version, I got error 404. On my v2.4 this was not an issue (it would provide printer information). After installing the full cb1 version (v2.3.3) for the Micron+, I was able to get printer info. It may have to do with the minimal version of cb1 and how it installs moonraker.

Anyway, closing this issue.