Purge line g code causing issue during print start.

[Johnn201]

Using the switchwire skr mini e3 v3 config file and superslicer with PRINT_START in the start gcode after print start having the Purge Line Gcode uncommented I get error:
Extruder not hot enough: If I manually preheat before PRINT_START I do not get this line.
7:15 AM
Move out of range: 5.000 5.000 3.000 [0.000]
7:15 AM
Move out of range: 5.000 5.000 3.000 [0.000]
If I comment it out it prints normally.
Uncommenting This..
##Purge Line Gcode
G92 E0;
G90
G0 X5 Y5 F6000
G0 Z0.4
G91
G1 X120 E30 F1200;
G1 Y1
G1 X-120 E30 F1200;
G92 E0;
G90
klippy.log

[Johnn201]

I have gotten rid of all but the error Extruder not hot enough by changing G0 X5 Y5 to G0 X20 Y20 F6000 but still get Extruder not hot enough unless I manually preheat the extruder, so still looking for a solution.

[Johnn201]

Scientist_Test_90mm1.txt

[nemgrea]

add

M109
M190

to the beginning of the purge g code

[Johnn201]

I'll try that thank you.

[Johnn201]

The M109
M190
Also did not fix the heating problem
Should "Only custom start GCode be checked in superslicer printer settings?