V0-Umbilical: No cutout for neopixel wire routing

[vavaroutsos]

I don't know how people have been routing the neopixel wiring, but the only way I see to get from the rear electronics area to the top of the build chamber is through the Y end stop switch cutout. This is too small for anything more than one set of neopixel wires. I think this cutout should be enlarged or additional cutouts should be added for neopixel wiring. Probably a better solution would be to put the neopixel strip connectors on the top side of the board, which is what I will do. Am I missing something?

[dajones89]

@vavaroutsos Not sure if this is too late but If you are carefull you can cut a notch out of the pcb, I used a hacksaw, I mirrored the notch for the endstop on the other side, Have on the left LED wiring, on the right LED wiring and Endstop wiring.

[vavaroutsos]

I modified the cover and added two holes for the neopixel connectors. Then I de-soldered them and installed them on the topside. I think this is the right solution if they are to be for case lights. Now I can easily unplug them if I need to remove the hinged top hat for any reason. Attached is the modified cover if you want to include it in the repo. Best Regards, Pete From: dajones89 ***@***.***> Sent: Saturday, November 26, 2022 3:28 PM To: VoronDesign/Voron-Hardware ***@***.***> Cc: Peter G. Vavaroutsos ***@***.***>; Mention ***@***.***> Subject: Re: [VoronDesign/Voron-Hardware] V0-Umbilical: No cutout for neopixel wire routing (Issue #179) @vavaroutsos <https://github.com/vavaroutsos> Not sure if this is too late but If you are carefull you can cut a notch out of the pcb, I used a hacksaw, I mirrored the notch for the endstop on the other side, Have on the left LED wiring, on the right LED wiring and Endstop wiring. — Reply to this email directly, view it on GitHub <#179 (comment)> , or unsubscribe <https://github.com/notifications/unsubscribe-auth/ADIUZJSMNFFE6OVZN6QBDL3WKKMJZANCNFSM6AAAAAAQYMKJDM> . You are receiving this because you were mentioned. <https://github.com/notifications/beacon/ADIUZJSAUBCLI6ICRVOOQALWKKMJZA5CNFSM6AAAAAAQYMKJDOWGG33NNVSW45C7OR4XAZNMJFZXG5LFINXW23LFNZ2KUY3PNVWWK3TUL5UWJTSPFGV2O.gif> Message ID: ***@***.*** ***@***.***> >