Becomes unresponsive during check command. Its crashed.

[rap2021]

Been like this for a few hours:

State of Elucidate @ unresponsive:

Questions:
1 - via logs or other approaches, can we tell if SnapRAID has crashed or Elucidate?
2 - During a Check process, may I assume nothing in the array - including parity and content files are damaged? I.e.: If I force quit the app, everything should be fine? ...I can attempt to recheck etc.?

[Smurf-IV]

1. SnapRaid was reporting 0% cpu which is strange, then it dumped an "Everything OK" message - Also Strange

• Did you se if SnapRaid was still running in the Apps -> Details tab of Task Manager?

2. Read on the SnapRaid forum, but I think yes, eveythin should be readonly during a check - Scrub is the more "Active one"

a) Did you have an addition option to Stop on first error ?
b) What version of SnapRaid Are you using ?
c) What version of Elucidate ?
d) can you compress the Elucidate logs for that run and attach to this please ?

[rap2021]

First I should say I am a newbie user. This is a new W10 build using a preexisting drive/data set.
However, I did an initial sync successfully. Then a scrub. Then added a few files to the array followed by another sync. All good. I'm not paranoid, but I'm new so I ran the check command.

I Ieft the system in the non-responding state over night - then I restarted the machine and another check is running.

Your questions:

1. No I did not.
2. OK - and confirmed
   a) No.
   b) SnapRAID 11.6 Windows x64
   c) Elucidate 21.4.1030.4
   d) Not sure how that is done. Log History is blank - and note the GUI issues in the upper left corner:

I am currently running another check - hoping that this was a "one-off" problem. Happy to provide you logs; but I'll need some direction. Thanks Simon.

[rap2021]

Current check is at 51%. Check is proceeding as before - but no crash yet, I decide to check the Task Manager as requested:

I'll report either way; but reopen if it crashes again.

[rap2021]

Last I checked it was at 60% - then just now, its back to 0%. What would cause it to start all over?

I have to say, that this is a problem. Running a check on 64TB's is a lengthy procedure - never mind if it stops midstream. Here I am - 3 days later - and its now at 1%.

[rap2021]

Thank-fully, check completed.

I would be curious on how to check logs.

[Smurf-IV]

Thanks for sticking with this..

I have Approx 48TB (protected by 3 *8TB drives), so you've definitely exceeded my current test capability (Still haven't filled up the rest of the possible space yet.).
How many Raid drives have you set ?

Thank-fully, check completed.

Yay

I would be curious on how to check logs.

Located here:

[rap2021]

There are 7x 8TB data drives protected by 1x 10TB parity drive. (I have a drive chassis expander and another 10 TB drive enroute - perhaps in a week.) All but one of the 7 drives are pretty full. (They have about 30-50GB's free.) The Parity drive has a 7.8 TP file on in.

logs.zip

Logs are attached.

[Smurf-IV]

Sorry it has been so long.
Issue has been raised here:
https://sourceforge.net/p/snapraid/discussion/1677233/thread/b825867020/