Hello Everyone. I'd like to ask for some help (sorry for my english, I speak spanish)
I'm working with a Raspberry b+ and i'm using the UART GPIO with the baudrate = 115200. (I ran the script to modify the baudrate)
At first I ran "raspberry_pi_GPIO_test.py" script and it worked fine ( CMOS led turns off when i put my finger on the sensor). Then I ran LegacyEnroll,py but the problem begins when it perform the "check enrolled" command, then it starts to check but the displays always finish saying "Failed: enroll storage is full". I also made a script to use the function "Delete All" but even by doing this, it didn't work.
This is the script I made to erase all ID's because i'm not sure if I wrote it in the right way
Thak you. I will appreciate your help
Hello Everyone. I'd like to ask for some help (sorry for my english, I speak spanish)
I'm working with a Raspberry b+ and i'm using the UART GPIO with the baudrate = 115200. (I ran the script to modify the baudrate)
At first I ran "raspberry_pi_GPIO_test.py" script and it worked fine ( CMOS led turns off when i put my finger on the sensor). Then I ran LegacyEnroll,py but the problem begins when it perform the "check enrolled" command, then it starts to check but the displays always finish saying "Failed: enroll storage is full". I also made a script to use the function "Delete All" but even by doing this, it didn't work.
This is the script I made to erase all ID's because i'm not sure if I wrote it in the right way
Thak you. I will appreciate your help