Valve and Flow Screen
Dynamic tanks are identified by either F-# or U-# where F is for facility, U is for unit, and # is the identifier. Facility tanks' identifiers will always count up from 1 starting from the top down to the bottom, whereas unit tanks will have an identifier matching the unit identifier. Unit tanks will always be drawn right next to the row for that particular unit, whereas facility tanks will be listed as early as they can be, based on the facility tank configuration. Note, these facility identifiers will match up to the RTU configuration's index field for those particular tanks, so be sure to match the config to where the screen shows the tank should be.
- OFF-LINE (yellow) → dynamic tank disconnected
- NOT FORMED (orange) → dynamic tank not formed
- RTU FAULT (orange) → PPM fault
- ONLINE (green) → connected, but not low fill or full (see below)
- LOW FILL (yellow) → fill percent < 20%
- FULL (green) → fill percent >= 99%
- OFF-LINE (yellow) → SPS disconnected
- NOT FORMED (orange) → SPS not formed
- RTU FAULT (orange) → PPM fault
- IDLE (green) → process rate is 0
- ACTIVE (green) → process rate is greater than 0