PLC not work :(

[domgggg]

The plc seems to not connect to the network. I updated the installer and the plc to the latest version but nothing on the monitors or plc is showing readings to the reactor or reactor plc being online
(also idk how to put images on these messages so once you respond ill reply with the screenshots I took)

[MikaylaFischler]

Yeah I'll need more info than that, such as screenshots you mentioned when you get the chance and/or the state of the PLC's NETWORK and STATUS lights.

I added this page recently, so I'll link it in case this is your problem: https://github.com/MikaylaFischler/cc-mek-scada/wiki/FAQ-and-Common-Problems#my-computers-wont-connect-to-each-other

[MikaylaFischler]

The red STATUS light indicates the PLC didn't fully start up and is waiting on peripherals, which in this case is elaborated on by the red REACTOR light indicating that there isn't a reactor connected. Is the PLC touching a Fission Reactor Logic Adapter or connected via a wired modem to one?

[domgggg]

Oh I connected using a wired modem to a reactor port.

[domgggg]

also theirs more problems still.

Every time I try to start the reactor from the monitor it says something about the units and it wont let me start it. Im just confused about the units.

[MikaylaFischler]

You can't run auto control mode until you assign a reactor unit to one of the non-manual assignments (primary, secondary, etc). You may find this page helpful: https://github.com/MikaylaFischler/cc-mek-scada/wiki/Operating-Procedure

[domgggg]

okay thank you al problems are fixed.