@patrickcleeve2
START_FROM:
- turn on microscope ops
DONE:
show microscope settings connected, tilt, gas, etc move to milling angle... etc
load profile as npy set settings: width, height , depth run optional initial milling
options to transpose, invert? Dont think we need transpose? invert profile convert to bmp
set top left corner position move to corner move to centre
TODO:
set milling position set milling pattern draw milling pattern in napari take ion image change to milling current on setup run milling
offset movement corner edge detection
profile decomposition multiple milling stages stitching
calibration
- run calibration pattern
- move to edge, milling multiple rectangles at different depths, see how deep they go, fit the actual sputtering rate / depth
- actually set to an application file??
STRETCH: - 3d profiles
docs
- setting patterns
- understanding bitmap millng