setup/config/

[giscus[bot]]

setup/config/

https://3ms.3dcoded.xyz/setup/config/

[RoyMessin]

You mention:
To use the 3MS, you'll need a filament sensor
Can you post a link to purchase?
It is not shown in the BOM nor here.

[3DCoded]

Hi @RoyMessin ,

A link isn't provided in the docs because every printer can use a different sensor. A good universal sensor is the Filatector.

[henriquetironi]

Hello, the filament sensor pin is in the main board or the board that are connected the motores, extra board ?

[3DCoded]

Hi @henriquetironi ,

The filament sensor can be plugged into any board Klipper has access to, including your printer board and the board running your 3MS.

[henriquetironi]

i put a endstop right after the Y

[3DCoded]

That would be classified as a shared gate sensor, so you would configure it like:

[mmu_sensors]
# If it's on your printer board
gate_switch_pin: ^some_pin

# If it's on your 3MS board
gate_switch_pin: ^mmu:some_pin

[henriquetironi]

thanks! i'm installing all the hardware first, after this i'll start with the software, i'ts kind a simply but i'm no a expert with this things, my printer is a sapphire plus with robin nano v3 and a pi3 and now a creality board for the 3ms, i have here 3 BMG extruder that i'm will use now